Home Outlet Cabinet Program Associate Resource Guide

A LICENSED PLUMBER OR ELECTRICIAN MAY BE REQUIRED ***Modifications for new Appliance Openings should be handled by the Appliance Installer**

CUSTOMER PURCHASED MATERIALS

LABOR

LABOR DESCRIPTION

ITEM #

UOM

INSTALLER PROVIDED MATERIALS

360026

EACH

Disconnect, basic removal, haul away, and disposal

Disconnect sink/faucet/disposer

Disconnect and remove sink/faucet/disposer

Install new or re-connect existing sink - includes: faucets, supply lines, drain lines, existing fixtures (i.e., re-connect disposal) in existing location only

Plumbing, fittings and connectors, adhesive, caulk, putty, Teflon tape

360028

EACH

Sink, drain (tail piece), basket, Faucet

Install permanent sink/faucet/disposer

360009 360010 360011 360012 360013 360014 360015 360016 360017

EACH EACH EACH EACH EACH EACH EACH EACH EACH

Disconnect / Reconnect Electric Range or Cooktop

Disconnect / Reconnect Electric Range or Cooktop for installation of cabinets

Disconnect / Reconnect Gas/LP Range or Cooktop for installation of cabinets *Installer will not convert to gas*

New flex line for gas.

Disconnect / Reconnect Gas/LP Range or Cooktop

Disconnect / Reconnect Dishwasher

Disconnect / Reconnect Dishwasher for installation of cabinets

Disconnect / Reconnect Refrigerator (including ice maker)

Disconnect / Reconnect Refrigerator (including ice maker) for installation of cabinets

Disconnect / Reconnect Electric Wall Oven

Disconnect / Reconnect Electric Wall Oven for installation of cabinets

Disconnect / Reconnect OTR Microwave

Disconnect / Reconnect OTR Microwave for installation of cabinets

Disconnect / Reconnect Electric Range Hood

Disconnect / Reconnect Electric Range Hood for installation of cabinets

Disconnect / Reconnect Exhaust fan (existing vent) for installation of cabinets. *Installer does not supply or run new duct work*

Disconnect / Reconnect Exhaust fan (existing vent)

Disconnect / Reconnect Trash Compactor

Disconnect / Reconnect Trash Compactor for installation of cabinets

CUSTOMER PURCHASED MATERIALS

LABOR

LABOR DESCRIPTION

ITEM #

UOM

INSTALLER PROVIDED MATERIALS

Installer measures and documents full room details. Assess job site for installation conditions, notes any possible obstacles with installation including but not limited to code work outside of scope and limitations. Installer to assess home for lead in homes built before 1978 (test if required) Installer to practice lead safe guidelines in homes testing positive for lead If needed - drywall patch to primer ready, meaning sanded and ready for primer. Does not include texturing to match. (NOT intended for full wall drywall replacement) Drywall ONLY - Not intended for backerboard, etc. Any additional work that may not be covered to perform the scope above. Plumbing shut off valves. Basic modiciations for cabinets plumbing and electrical covered here. Not intended for major structural modifcations, work behind the wall, cutting concrete, or work below grade. Total Job labor retail minimum = $800 if labor quoted is below minimum additional fee will be applied to bring up to $800 (calculated as differece in quote to the miminum) Installer supplied permit to perform work quoted based on any local, state or federal requirements

360000

EACH

Measurement Fee

Room measurements, drawing and documented job site conditions

Measurement fee

Any and all materials needed to perform lead safe practices and maintain a safe working environment for installer and customer.

360033 CUSTOM QUOTE

Cabinet Lead Safe Practices

360030

SQFT

Drywall, tape, mud, corner beads, sandpaper, etc.

Drywall Patch Work

360031 FLAT RATE

Permit Fee(s)

Permit

360034 CUSTOM QUOTE

Custom Work Cabinets

360035 FLAT RATE

Minimum Job Cost

Additional mileage if customer's home is over 25 mile radius from store of purchase.

360032 PER MILE

Mileage

360040 FLAT RATE

Trip Charge*

Trip Charge to cover additional CCI trip for materials not present at job site or damaged.

*Please be advised that a trip fee of $150 will apply if the CCI is required to make an additional trip back to the store to pick up materials post-cabinet delivery. This fee will only be charged if the additional trip is due to an oversight or error by the retailer or product vendor. If the trip is necessary due to an error on the part of the installer, no trip fee will be charged. REV 1.10.2025